Help Appliance

In-home appliance repair across Northern Virginia

Questions? (571) 535-5759
Washing machine repair

Washing Machine Repair in Northern Virginia

Washer stopped mid-cycle with a drum full of water? Leaking, shaking hard or flashing a code? Tell us where the cycle stops and whether it is front-load, top-load or stacked. We take it from there.

Technician inspecting the door seal of a front-load washing machine
Where did it stop?
  • During fill
  • Mid-wash
  • Before the spin
  • Draining
  • At the end
Quick answer

Why won't my washing machine spin?

Most washers refuse to spin for a reason they are designed around: the load is off balance, the cycle uses a low or no-spin setting, the door or lid has not locked, or water has not drained out of the drum. The machine protects itself and stops.

If a balanced load on a normal cycle still won't spin, or water stays in the drum, something in the drain, lock or drive system needs a technician. Tell us whether you heard the pump run and any code on the display.

What to tell us by washer type
Front-loadWhether the door stays locked, any code, and if water shows behind the bottom-front panel.
Top-loadWhether the lid lock clicks, the agitator or plate moves, and how full the tub is.
StackedWhich unit is failing, and whether the closet door opens fully for access.
All-in-one comboWhether the wash, the dry or both are affected.
What we fix

Washer problems we repair

Each of these has a short list of likely causes. The detail in the right column is what helps us bring the right parts.

  • 01

    Won't spin or spins slowly

    Tell us if it happens with every load or only large ones, and which cycle you used.

  • 02

    Won't drain

    Note whether you hear the pump humming and how much water is left in the drum.

  • 03

    Stops mid-cycle or shows a code

    Write the code exactly as shown, letters and dashes included.

  • 04

    Leaks during a wash

    Say where the water appears: front, under the machine, or behind it near the hoses.

  • 05

    Shakes, bangs or grinds

    Let us know if it happens on balanced loads too, and whether the noise is new.

  • 06

    Door or lid won't lock or unlock

    Do not force it open. Tell us if the cycle starts at all.

Before you book

Three checks that might save a visit

  1. Rebalance the load

    Wait for the door to unlock, spread heavy items like towels or a bath mat evenly, or split the load in two.

  2. Run drain and spin once

    Choose the drain-and-spin or rinse-and-spin setting. If it spins now, the load was the cause.

  3. Check the setting and detergent

    Delicate and wool cycles spin slowly by design. Too much detergent can leave suds that stop a front-loader.

Water on the floor? Stop the cycle and close the hot and cold valves behind the washer if you can reach them safely. Burning smell or a tripped breaker? Unplug only if the plug is easy to reach, and do not run it again.

More safe checks: Why your washer won't spin

Washers we work on

Front-load, top-load, stacked or combo

The layout of your laundry space matters as much as the brand. Mention a tight closet or basement stairs when you book.

Front-load

Door locks, drain pump filters, bearings and door seals.

Top-load

Lid switches, agitators, drive parts and drain issues.

Stacked

Washer-dryer towers in closets and townhouse halls.

All-in-one combo

Single units that wash and dry in the same drum.

Booking

What we ask for, and what it costs to start

Your request, in one minute

  • Service ZIPWhere the washer is installed
  • Brand and typeFront-load, top-load, stacked or combo
  • The cycleWhich one, and where it stops
  • Water in the drum?Yes, no, or how much
  • Error codeExactly as shown, if any
  • Callback numberWhere we can reach you
Diagnostic visit$100–$150

Depending on your area. You hear the exact amount when we call, before anything is booked.

  • Waived when you approve the repair
  • Written quote with parts, labor and total
  • Drain and spin tested before we leave
  • Manufacturer's parts warranty where one applies
Service areas

Washer repair across Northern Virginia

We confirm your exact address when we call. We also serve parts of Maryland.

FAQ

Washing machine repair questions

Should I drain the washer before the visit?

Only if your manual explains how and the water has cooled. A front-loader can release a lot of water from the drain filter, so have towels and a shallow pan ready. Otherwise leave it and tell us water is in the drum.

Can you repair a stacked washer and dryer?

Yes. Tell us it is stacked, the brand, and whether the closet door opens fully. The technician handles any unstacking needed for access.

How much does a washer repair visit cost?

The diagnostic visit is $100 to $150 depending on your area, and it is waived if you approve the repair. You get the full price in writing first.

Is it safe to open the door with water inside?

No. Wait for the door to unlock on its own, and drain the water first using the method in your manual.

Is an older washer worth repairing?

Compare the written quote with the cost of a comparable new washer plus delivery and installation. Our guide on repairing or replacing an appliance walks through it.

Laundry piling up? Let's get it spinning.

Send your ZIP, washer type and where the cycle stops.